MODEL: R30NECT1

R30NECT1 SPECIFICATIONS

ES-9009 Rev.9 Page 1/3

https://www.m-system.co.jp/

Remote I/O R30 Series

NETWORK MODULE

(EtherCAT)

Functions & Features

• Interchanges analog or discrete I/O signals with the

filedbus (EtherCAT)

• Combined with R3 Series I/O modules

EtherCAT® is a registered trademark and patented

technology, licensed by Beckhoff Automation GmbH,

Germany.

mm [inch]

98

[3.86]

110

[4.33]

25 [.98]

MODEL: R30NECT1[1]

ORDERING INFORMATION

• Code number: R30NECT1[1]

Specify a code from below for [1].

(e.g. R30NECT1/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

CAUTION

• R3 series I/O modules can be added by using an

installation base for R3 I/O module extension (model:

R30EBS). Note that the firmware version must be 1.04.x or

later.

• When using the extension base, be sure to install at least

one R30 I/O module on the R30BS, otherwise

communication error occurs.

• The internal bus communication period for R3 series I/O

modules installed on the R30EBS is as follows.

Internal bus communication period = 6 msec. × number of

I/O module + 10 msec. (Data update period of main CPU)

Example: Four R3 I/O modules

6 msec. × 4 + 10 msec. = 34 msec.

Even when the R30EBS is mounted to the R30BS, the

internal bus communication period of R30 series is kept to

approx. 1 msec.

RELATED PRODUCTS

• PC configurator software (model: R30CFG)

• PC configurator software (model: R3CON)

• ESI file

The ESI file and configurator software are downloadable at

M-System’s web site.

For connecting to PC, use commercially available Mini-B

type USB cable. (provided by user)

• R3 series I/O modules (except R3-TC2)

GENERAL SPECIFICATIONS

Connection

EtherCAT: RJ-45 connector

Internal bus: Via the Installation Base (model: R30BS)

Internal power: Via the Installation Base (model: R30BS)

Isolation: EtherCAT to internal bus or internal power

Internal bus communication cycle: Approx. 1 msec.

Status indicators: PWR, RUN, ERR, L/A IN, L/A OUT

(Refer to the instruction manual.)

EtherCAT COMMUNICATION

Standard: IEEE 802.3u

Transmission type: 100BASE-TX

Transmission speed: Full-duplex 100 Mbps

Transmission media: 100BASE-TX (STP cable; Category 5e)

Maximum internode length: 100 meters

Fixed address: Set with rotary switches

(The master must support MDP.)

INSTALLATION

Current consumption: 110 mA

Operating temperature: -10 to +55°C (14 to 131°F)

Storage temperature: -20 to +65°C (-4 to +149°F)

Operating humidity: 10 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R30BS)

Weight: 110 g (0.24 lb)