MODEL: C-HCL-A

C-HCL-A SPECIFICATIONS

ES-9250 Rev.4 Page 2/4

http://www.m-system.co.jp/

EXTERNAL VIEW

(7) Current Adjuster

(8) Current Switch

(Fixed/Variable)

(10) POWER LED

(13) Stand

(14) Battery Cover

(11) POWER Switch

(12) 2-wire Loop/4-wire

Mode Switch

(1) Monitor Switch

(2) Output Jack (+)

(5) Monitor Jack (+)

(6) Monitor Jack (–)

(4) Strap Holder

(3) Output Jack (–)

(9) Monitor Jack Cover

■ FUNCTIONAL DESCRIPTIONS

NAME

FUNCTION

(1) Monitor Switch

To enable the monitoring function, slide from S to M.

(2), (3) Output Jacks (+), (–)

Connect the test leads to + (red) and – (black).

(4) Strap Holder

Put a strap through this holder to suspend the checker.

(5), (6) Monitor Jacks (+), (–)

To monitor a current value, insert the test lead pins of a measurement device into these jacks:

red pin to (+) and black pin to (–).

(7) Current adjuster

Adjustable continuously in the range of 0 to 24mA while the Current Switch (8) is held at the VR

position.

(8) Current Switch (Fixed/Variable)

Fixed value is selectable from 4, 12, and 20mA.

(9) Monitor Jack Cover

To use the monitoring function, remove the cover.

(10) POWER LED

Red LED turns on when the power is on.

(11) POWER Switch

Switch ON and OFF for the checker.

(12) 2-wire Loop/4-wire Mode Switch

Current output is selectable from two modes, 2-wire loop (sink) and 4-wire (source).

(13) Stand

Pull the bar to set the checker in the upright position.

(14) Battery Cover

To replace a battery, remove the cover.