GAPTEC-Electronic GmbH & Co. KG

sales@gaptec-electronic.com – www.gaptec-electronic.com

Page 4 of 5

LEDW10_24_P – Rev. 2018-1.1

Specifications subject to change without notice.

LEDW10_24_P Series

Constant current power LED Driver with PWM dimming - Wide Input -

Non-Isolated & Regulated

PWM dimming control

For PWM dimming signals with a certain frequency, the output current

of the driver is related to the duty ratio of PWM signal. Refer to the

formula for the calculation method:

Where, Io_set represents required output current (mA); D represents the

duty ratio (%) of PWM signal; T represents the period (ms) of PWM sig-

nal; and Io_norm represents the rated output value (mA) of the driver.

Note: The formula is for reference only; and deviation of output cur-

rent may exist due to various loads. The min. conducted time of PWM

signal shall not be less than 0.8ms, or the product will be in abnormal

operation; in case of low voice from the driver during PWM dimming, it

is normal since the PWM dimming frequency is within the auditory fre-

quency range of human ears (20Hz-20KHz in general). To prevent seeing

flash of the LED by human eyes, it is suggested to set the PWM dimming

frequency between 100-200Hz.

EMI/RFI conducted EN55022 Class B recommended circuit

Components

Specifications

C1

225K/50V 1210 ×7R (TORCH)

C2, C4

104K/50V 1210 ×7R (TORCH)

L1

PI043-131MT (SHENZHEN

CEAIYA)

LEDW10_24_P

Typical characteristics