TMP47P201 datasheet(22/32 Pages) TOSHIBA

22 / 32 page

22/32

TOSHIBA CORPORATION

TMP47C101/201

(1)

Ports R4 (R43 to R40), R5 (R53 to 50)

These ports are 4-bit I/O ports with a latch. When used

as an input port, the latch must be set to “1”. The latch

is initialized to “1” during reset. Port R4 can directly

drive LEDs.

These 2 ports (8 pins) can be set, cleared, and tested

for each bit as speciﬁed by L register indirect address-

ing bit manipulation instructions ([SET @L], [CLR @L],

and [TEST @L]). Table 3-1 lists the pins (I/O ports) that

correspond to the contents of L register.

Example:

To clear R43 output as specified by the L

instruction.

L, #00011B

; Sets R43 pin address to L

CLR @L

; R43 0

Table 3-2. Relationship Between L Register Contents and I/O Port Bits.

Figure 3-3. Ports R4, R5

(2)

Port R8 (R81 to R80) and Port KE

Port R8 is a 2-bit I/O port with a latch.When used as

an input port, the latch must be set to “1”. The latch is

initialized to “1” during reset.

Port R8 is shared with the external interrupt input pin

and the timer/counter input pin. To use this port for

one of these functional pins, the latch should be set to

“1”. To us it for an ordinary I/O port, the acceptance of

external interrupt should be disabled or the event

counter/pulse width measurement modes of the timer/

counter should be disabled.

R82, R83 pins do not exist actually but R82, R83 has

the latch. And R82 is wired to HOLD (INT1) pin, inter-

nally.

Port KE (KEO) is a 1-bit sense input port shared with

the hold request/release signal input in (HOLD). This

input port is assigned to the least signiﬁcant bit of port

address IPOE and is processed as the data with

inverted polarity. For example, if an input instruction is

executed with the pin on the high level, ”0” is read. The

bit1 to bit3 of port KE, and undeﬁned value is read

when an input instruction is executed.

Note:

When HOLD (INT1) pin is used for an I/O port, external interrupt 1

occurs upon detection of the falling edge of pin input, and if the

interrupt enable master ﬂip-ﬂop is enabled, the interrupt request is

always accepted. So that a dummy interrupt processing must be

performed (only the interrupt return instruction [RETI] is executed).

With R80 (INT2) pin, external interrupt 2 occurs like HOLD (INT1)

in but bit 0 of the interrupt enable register (EIR0) is only kept at

“0”not accepting the interrupt request.

TMP47P201 bảng dữ liệu(PDF) 22 Page - Toshiba Semiconductor

TMP47P201 bảng dữ liệu(HTML) 22 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

bảng dữ liệu tải về

Link URL