Pipe Sealant Anaerobic Adhesives

HP42 • HP45 • PS65 • PS67 • PS77

Handling

Information

Directions for Use:

use on most plastics due to potential cracking of plastic parts. Also, they are not

recommended for use in piping systems that contain pure oxygen or an oxygen-

rich environment, chlorine, or strong oxidizing substances.

For Assembly:

1. Ensure parts are clean, dry and free from oil, grease and dirt. For best

Activator. (Activator can also be used on inactive surfaces or to accelerate

the cure on active surfaces.)

Activator may reduce bond strength depending on substrates and gap.

Testing is recommended to evaluate the effect.

2. If not sure of surface type, always use activator. Refer to Material surface

Activity and Cure Speed section for more information.

3. Apply sealant onto the second and third threads (not the first thread) of the

male fitting so as to avoid introducing uncured sealant into the system.

(However, should uncured sealant get into the piping system, it will not

cure or cause blockage and can be slushed out.) Avoid touching the metal

surfaces with the bottle tip since the metal ions may react with the

adhesive upon contact and eventually may clog the bottle tip.

4. Spread adhesive evenly around the male fitting.