USB334X datasheet(12/92 Pages) MICROCHIP

tên linh kiện	USB334X

Giải thích chi tiết về linh kiện	Enhanced Single Supply Hi-Speed USB ULPI Transceiver

PDF	92 Pages

Scroll/Zoom	100%

nhà sản xuất	MICROCHIP [Microchip Technology]

Trang chủ	http://www.microchip.com

Logo

12 / 92 page

USB334x

DS00002646A-page 12

 2009-2018 Microchip Technology Inc.

RESETB

Input,

CMOS,

Low

When low, the part is suspended and the 3.3V and

1.8V regulators are disabled. When high, the

USB334x will operate as a normal ULPI device, as

described in Section 5.6.2. The state of this pin may

be changed asynchronously to the clock signals.

When asserted for a minimum of 1 microsecond and

then de-asserted, the ULPI registers are reset to

their default state and all internal state machines are

reset.

VDD18

Power

N/A

1.8V Regulator Output. A 1.0uF (<1 ohm ESR)

bypass capacitor to ground is required for regulator

stability. The bypass capacitor should be placed as

close as possible to the USB334x.

STP

Input,

CMOS

High

The Link asserts STP for one clock cycle to stop the

data stream currently on the bus. If the Link is

sending data to the PHY, STP indicates the last byte

of data was on the bus in the previous cycle.

FLAG

GND

Ground

N/A

Ground.

TABLE 2-2:

USB3343 PIN DESCRIPTIONS (CONTINUED)

Name

Direction/

Type

Active

Level

Description

USB334X bảng dữ liệu(PDF) 12 Page - Microchip Technology

USB334X bảng dữ liệu(HTML) 12 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92

bảng dữ liệu tải về

Link URL