ROMSPG3.01 datasheet(27/31 Pages) U-BLOX

tên linh kiện	ROMSPG3.01

Giải thích chi tiết về linh kiện	u-blox M8 Concurrent GNSS Antenna Modules

PDF	31 Pages

Scroll/Zoom	100%

nhà sản xuất	U-BLOX [u-blox AG]

Trang chủ	https://www.u-blox.com/

Logo

27 / 31 page

CAM-M8 - Data Sheet

UBX-15031574 - R04

Default messages

Page 27 of 31

Production Information

8 Default messages

Interface

Settings

UART Output

9600 Baud, 8 bits, no parity bit, 1 stop bit

Configured to transmit both NMEA and UBX protocols, but no UBX messages and only the

following NMEA have been activated at start-up:

GGA, GLL, GSA, GSV, RMC, VTG, TXT

UART Input

9600 Baud, 8 bits, no parity bit, 1 stop bit, Autobauding disabled

Automatically accepts following protocols without need of explicit configuration:

UBX, NMEA, RTCM

The GPS receiver supports interleaved UBX and NMEA messages.

DDC

Fully compatible with the I2C industry standard, available for communication with an external host

CPU or u-blox cellular modules, operated in slave mode only.

NMEA and UBX are enabled as input messages, only NMEA as output messages

Maximum bit rate 400 kb/s.

TIMEPULSE

(1 Hz Nav)

1 pulse per second, synchronized at rising edge, pulse length 100 ms

Table 10: Default messages

☞ Refer to the u-blox 8 / u-blox M8 Receiver Description Including Protocol Specification [2] for

information about further settings.

ROMSPG3.01 bảng dữ liệu(PDF) 27 Page - u-blox AG