W5200 datasheet(49/88 Pages) WIZNET

49 / 88 page

Confirm the reception of the TCP data.

First method :

{

if (Sn_IR(RECV) == ‘1’) Sn_IR(RECV) = ‘1’; goto Receiving Process stage;

/* In this case, if the interrupt of Socket n is activated, interrupt occurs. Refer to IR,

IMR Sn_IMR and Sn_IR. */

}

Second Method :

{

if (Sn_RX_RSR0 != 0x0000) goto Receiving Process stage;

}

The First method: set the Sn_IR(RECV) to ‘1’ whenever you receive a DATA packet. If the

host receives the next DATA packet without setting the Sn_IR(RECV) as ‘1’ in the prior

DATA packet, it cannot recognize the Sn_IR(RECV) of the next DATA packet. This is due

to the prior Sn_IR(RECV) and next Sn_IR(RECV) being overlapped. So this method is not

recommended if the host cannot perfectly process the DATA packets of each Sn_IR(RECV).

ESTABLISHMENT : Receiving process

In this process, it processes the TCP data which was received in the Internal RX memory.

At the TCP mode, the W5200 cannot receive the data if the size of received data is

larger than the RX memory free size of Socket n . If the prior stated condition is

happened, the W5200 holds on to the connection (pauses), and waits until the RX

memory’s free size is larger than the size of the received data.

{

/* first, get the received size */

len = Sn_RX_RSR;

// len is received size

/* calculate offset address */

src_mask = Sn_RX_RD&gSn_RX_MASK;

// src_mask is offset address

/* calculate start address(physical address) */

src_ptr = gSn_RX_BASE + src_mask;

// src_ptr is physical start address

/* if overflow SOCKET RX memory */

If((src_mask + len) > (gSn_RX_MASK + 1))

{

/* copy upper_size bytes of source_ptr to destination_address */

upper_size = (gSn_RX_MASK + 1) – src_mask;

memcpy(src_ptr, dst_ptr, upper_size);

/* update destination_ptr */

dst_address += upper_size;

W5200 bảng dữ liệu(PDF) 49 Page - WIZnet Co., Ltd