AM29LV033MU datasheet(27/56 Pages) AMD

27 / 56 page

November 11, 2002

Am29LV033MU

ADV ANCE

I N FO RMAT I O N

Figure 4.

Write Buffer Programming Operation

Write “Write to Buffer”

command and

Sector Address

Write number of addresses

to program minus 1(WC)

and Sector Address

Write program buffer to

flash sector address

Write first address/data

Write to a different

sector address

FAIL or ABORT

PASS

Read DQ7 - DQ0 at

Last Loaded Address

Read DQ7 - DQ0 with

address = Last Loaded

Address

Write next address/data pair

WC = WC - 1

WC = 0 ?

Part of “Write to Buffer”

Command Sequence

Yes

Abort Write to

Buffer Operation?

DQ7 = Data?

DQ5 = 1?

DQ1 = 1?

Write to buffer ABORTED.

Must write “Write-to-buffer

Abort Reset” command

sequence to return

to read mode.

Notes:

When Sector Address is specified, any address in

the selected sector is acceptable. However, when

loading Write-Buffer address locations with data, all

addresses must fall within the selected Write-Buffer

Page.

DQ7 may change simultaneously with DQ5.

Therefore, DQ7 should be verified.

If this flowchart location was reached because

DQ5= “1”, then the device FAILED. If this

flowchart location was reached because DQ1=

“1”, then the Write to Buffer operation was

ABORTED. In either case, the proper reset

command must be written before the device can

begin another operation. If DQ1=1, write the

Write-Buffer-Programming-Abort-Reset

command. if DQ5=1, write the Reset command.

See Table 10 for command sequences required for

write buffer programming.

(Note 3)

(Note 1)

(Note 2)

AM29LV033MU bảng dữ liệu(PDF) 27 Page - Advanced Micro Devices

AM29LV033MU bảng dữ liệu(HTML) 27 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

bảng dữ liệu tải về

Link URL