Model No. LMT070DNDFWD

9 Precautions for Use of LCD Modules

9.1 Handling Precautions

9.1.1 The display panel is made of glass. Do not subject it to a mechanical shock by

dropping it from a high place, etc.

9.1.2 If the display panel is damaged and the liquid crystal substance inside it leaks out,

be sure not to get any in your mouth, if the substance comes into contact with

your skin or clothes, promptly wash it off using so

9.1.3 Do not apply excessive force to the display surface or the adjoining areas since

this may cause the color tone to vary.

9.1.4 The polarizer covering the display surface of the LCD module is soft and easily

scratched. Handle this polarizer carefully.

9.1.5 If the display surface is contaminated, breathe on the surface and gently wipe it

with a soft dry cloth. If still not completely clear, moisten cloth with one of the

following solvents:

— Isopropyl alcohol

— Ethyl alcohol

Solvents other than those mentioned above may damage the polarizer.

Especially, do not use the following:

— Water

— Ketone

— Aromatic solvents

9.1.6 Do not attempt to disassemble the LCD Module.

9.1.7 If the logic circuit power is off, do not apply the input signals.

9.1.8 To prevent destruction of the elements by static electricity, be careful to maintain

an optimum work environment.

a. Be sure to ground the body when handling the LCD Modules.

b. Tools required for assembly, such as soldering irons, must be properly ground.

c. To reduce the amount of static electricity generated, do not conduct assembly

and other work under dry conditions.

d. The LCD Module is coated with a film to protect the display surface. Be care

when peeling off this protective film since static electricity may be generated.

The information contained herein is the exclusive property of SHENZHEN TOPWAY TECHNOLOGY CO.,LTD.

and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission of

SHENZHEN TOPWAY TECHNOLOGY CO.,LTD..

Page 20 of 21