General Operation

For the first five minutes after powering up, the Node operates in fast sample mode, sampling and sending data every two

seconds. After five minutes, the Node defaults to five minute sample intervals and the LCD turns off to save power, which is ideal

for the battery-powered models. Use the DIP switches or the User Configuration Tool (UCT) software to set the sample rate.

To activate fast sample mode, single-click button 1. LED 2 is on (amber) during the fast sample mode. To exit fast sample mode

and turn off the LCD, click button 2 five times.

Sensors with a Serial Interface

The following sensors are designed to be used with any of the 1-Wire Serial Interface Nodes.

K50UX1RA

•

U-GAGE Ultrasonic Sensor with 1-

wire serial interface

•

Datasheet:

191599

M12FTH4Q

•

Temperature and Humidity Sensor,

±2% Accuracy, 1-wire serial

interface

•

(Requires a 5-pin threaded M12/

Euro-style double-ended cordset

less than 3 meters long, such as

model DEE2R-5

xD.)

•

Datasheet:

162669

M12FT4Q

•

Temperature Sensor with 1-wire

serial interface

•

(Requires a 5-pin threaded M12/

Euro-style double-ended cordset

less than 3 meters long, such as

model DEE2R-5

xD.)

•

Datasheet:

162669

QM42VT1

•

Vibration and temperature sensor

with 1-wire serial interface

•

Detects dual-axis vibration

•

Zinc alloy housing

•

3 m cable with a 5-pin M12/Euro-

style male quick disconnect (QD)

•

Datasheet:

186209

QM42VT1QP

•

Vibration and temperature sensor

with 1-wire serial interface

•

Detects dual-axis vibration

•

Zinc alloy housing

•

150 mm (6 in) PVC cable with a 5-

pin M12/Euro-style male quick

disconnect (QD)

•

Datasheet:

186209

QS30WEQ

•

WORLD-BEAM Photoelectric

Emitter, QS30 (Max Range: 100

feet, 10x excess gain at 50 feet), 1-

wire serial interface

•

Datasheet:

140987

QS30WRQ

•

WORLD-BEAM Photoelectric

Receiver, QS30 (Max Range: 100

feet, 10x excess gain at 50 feet), 1-

wire serial interface

•

Datasheet:

140987

Configuration Instructions

Setting Up Your Wireless Network

To set up and install your wireless network, follow these steps.

Disconnect the power from your Sure Cross devices.

1. Configure the DIP switches of all devices.

2. If your device has I/O, connect the sensors to the Sure Cross devices. If your device does not have I/O, skip this step.

2

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 204221 Rev. A