Configuration

PVA configuration is accomplished using the DIP switches on the emitter and receiver as shown. When setting the DIP switches, use the

supplied plastic screwdriver to avoid damaging the switches or causing a short circuit.

Cover Removal

Cover Replacement

Insert a fingernail or small screwdriver into

the slot; apply gentle pressure, angling

away from the sensor lens. The cover will

remain tethered to the sensor housing.

To replace the switch cover, align one edge of the cover with the edge of the sensor

housing opening. Then press the front corners into place.

The switches determine four status operating modes:

• A/B frequency (to avoid crosstalk from multiple pairs of sensors)

• Light/dark operate

• Solid/flashing job light (depending on assembler and/or supervisor preference)

• Gate polarity

PVA Configuration DIP Switch Settings

*default settings

Switch

Emitter

Receiver

1 2 3 4

O

F

F

O

N

ON

OFF

Example Shown:

Switch #1

OFF

Switch #2

ON

Switch #3

OFF

Switch #4

ON

Figure 5. Configuration DIP switch setting positions

*ON = Frequency A

OFF = Frequency B

*ON = Frequency A

OFF = Frequency B

2

No function

ON = Light operate

*OFF = Dark operate

3

*ON = Job light steady

OFF = Job light flashes

*ON = Job light steady

OFF = Job light flashes

4

Job light control input: connect the white wire of the emitter and

receiver as follows:

Models PVA...P6

ON = Job light ON for +5 to 30V dc (27K input impedance)

*OFF = Job light ON for 0 to 2V dc/open circuit

Models PVA...N6

ON = Job light ON for +5 to 30V dc/open circuit

*OFF = Job light ON for 0 to 2V dc (10K input impedance)

3 Both emitter and receiver must be set to the same frequency in order to operate.

PVA Pick-to-Light Array

4

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 52088 Rev. F