Method

Action

Result

Remote Line

Single-pulse the remote line.

T

The sensor waits for the sensing condition.

Power LED Indicator: OFF

Output LED Indicator: Double-flash

2. Set the sensing condition.

Method

Action

Result

Push Button

Present the sensing condition, then five-click the push

button.

TEACH Accepted

Power LED Indicator: Flashes 3 times, then

solid green

Output LED Indicator: OFF6, then ON or OFF,

depending on the output state

The sensor returns to Run mode with the new

settings.

TEACH Not Accepted

Power LED Indicator: OFF

Output LED Indicator: Slow flash (1 Hz)

The sensor returns to the wait state, ready for

the sensing condition.

Remote Line

Present the sensing condition, then five-pulse the remote line.

T

T

T

T

T

T

T

T

T

Window Set

Darkest

(no signal)

Most Light

(saturated

signal)

Single

Presented

Condition

Output OFF

Output OFF

Output

ON

Sensor positions

window thresholds

≈12.5%

from the

presented condition

12.5%

Figure 7. Window Set (Light Operate shown)

• In Window Set, the single ON condition window extends

approximately 12.5% above and below the presented condition

when Light Operate is selected. Output ON and OFF conditions

may be reversed by changing the Light-/Dark-Operate setting (see

Sensor Setup on page 3).

• Lighter or darker conditions outside of the window cause the

output to change state.

• Window Set is recommended for applications where the target to

be sensed may not always appear in the same place, or when

other unwanted signals may appear.

1. Access the Window Set mode.

Method

Action

Result

Push Button

Press and hold the push button 2 to 4 seconds.

The sensor waits for the sensing condition.

Power LED Indicator: OFF

Output LED Indicator: Slow flash (1 Hz)

Remote Line

Single-pulse the remote line.

T

The sensor waits for the sensing condition.

Power LED Indicator: OFF

Output LED Indicator: Double-flash

2. Set the sensing condition.

Method

Action

Result

Push Button

Present the sensing condition, then double-click the push

button.

TEACH Accepted

Power LED Indicator: Flashes 3 times, then

solid green

Output LED Indicator: OFF7, then ON or OFF,

depending on the output state

The sensor returns to Run mode with the new

settings.

TEACH Not Accepted

Power LED Indicator: OFF

Output LED Indicator: Slow flash (1 Hz)

The sensor returns to the wait state, ready for

the sensing condition.

Remote Line

Present the sensing condition, then double-pulse the

remote line.

T

T

T

6 The initial output LED indicator condition is simultaneous with the power LED indicator 3-flash.

7 The initial output LED indicator condition is simultaneous with the power LED indicator 3-flash.

P/N 136564 Rev. E

www.bannerengineering.com - Tel: +1-763-544-3164

7