Wiring

NPN

Shield*

*It is recommended that the shield wire be connected to

either earth ground or DC common.

12-24V dc

4-20 mA

or 0-10V

100 mA

Maximum

–

+

1

3

2

4

5

Remote

Teach

Load

Discrete

PNP

Shield*

*It is recommended that the shield wire be connected to

either earth ground or DC common.

12-24V dc

4-20 mA

or 0-10V

100 mA

Maximum

–

+

1

3

2

4

5

Remote

Teach

Load

Discrete

Cabled wiring diagrams are shown. Quick disconnect wiring diagrams are functionally identical.

Configuring a Sensor

Window Limits

Window limits can be taught to the sensor in several ways, using either the push buttons on the back of the sensor or remote input.

Note: When the sensor changes state between PROGRAM and RUN modes, all of the LED indicators turn OFF momentarily,

before the appropriate LEDs come ON as described below. The sensing window limits expand temporarily to full scale (max

range) during PROGRAM mode.

Remote Input

To program the sensor remotely or to disable the keypad, use the Remote Programming function. In addition to programming the sensor, use the

remote input to disable the buttons for security, preventing unauthorized or accidental programming changes. Connect the gray wire of the sensor to

+12 V dc to 24 V dc, with a remote programming switch connected between them.

Note: The impedance of the remote teach input is 55 kΩ.

Programming is accomplished by following the sequence of input pulses. The duration of each pulse (corresponding to a push button “click”), and

the period between multiple pulses, are defined as: 0.04 seconds < T < 0.8 seconds.

Note: To exit PROGRAM mode without saving any changes, hold the Remote line high > 2 seconds (before teaching the second

limit). The sensor reverts to the last saved program.

P/N 57438 Rev. D

www.bannerengineering.com - Tel: + 1 888 373 6767

3