LP5012 datasheet(32/40 Pages) TI1

tên linh kiện	LP5012

Giải thích chi tiết về linh kiện	9-, 12-Channel, 12-Bit PWM Ultra-low Quiescent Current I2C RGB LED Drivers

PDF	40 Pages

Scroll/Zoom	100%

nhà sản xuất	TI1 [Texas Instruments]

Trang chủ	http://www.ti.com

Logo

32 / 40 page

RIREF=KIREF ×

VIREF

ISET

LP5009, LP5012

SLVSEH2 – MAY 2019

www.ti.com

Product Folder Links: LP5009 LP5012

Submit Documentation Feedback

Typical Application (continued)

9.2.1 Design Requirements

Set the LED current to 15 mA using the RIREF resistor. Select the proper value for the other external components,

like VCAP pin capacitor and the SCL/SDA pullup resisters.

9.2.2 Detailed Design Procedure

LP50xx scales up the reference current (IREF) set by the external resistor (RIREF) to sink the output current (IOUT)

at each output port. The following formula can be used to calculate the external resistor (RIREF):

(2)

The SCL and SDA lines must each have a pullup resistor placed somewhere on the line (the pullup resistors are

normally located on the bus master). In typical applications, values of 1.8 kΩ to 4.7 kΩ are used.

VCAP is internal LDO output pin. This pin must be connected through a 1-µF capacitor to GND. Place the

capacitor as close to the device as possible.

TI recommends having a 1-µF capacitor between VCC and GND to ensure proper operation. Place the capacitor

as close to the device as possible.

LP5012 bảng dữ liệu(PDF) 32 Page - Texas Instruments