| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
GD5F2GQ4RFZIH bảng dữ liệu(PDF) 35 Page - GigaDevice Semiconductor (Beijing) Inc. |
|
|
|||||||||||||||||||||||||||||
GD5F2GQ4RFZIH bảng dữ liệu(HTML) 35 Page - GigaDevice Semiconductor (Beijing) Inc. |
|
35 / 47 page ![]() SPI(x1/x2/x4) NAND Flash 2G 35 14.5 Internal ECC The serial device offers data corruption protection by offering optional internal ECC.READs and PROGRAMs with internal ECC can be enabled or disabled by setting feature bit ECC_EN. ECC is enabled after device power up, so the default READ and PROGRAM commands operate with internal ECC in the “active” state. To enable/disable ECC, perform the following command sequence: • Issue the SET FEATURES command (1FH). • Set the feature bit ECC_EN as you want: 1. To enable ECC, Set ECC_EN to 1. 2. To disable ECC, Clear ECC_EN to 0. During a PROGRAM operation, the device calculates an ECC code on the 2k page in the cache register, before the page is written to the NAND Flash array. During a READ operation, the page data is read from the array to the cache register, where the ECC code is calculated and compared with the ECC code value read from the array. If error bits are detected, the error is corrected in the cache register. Only corrected data is output on the I/O bus. The ECC status bit indicates whether or not the error correction was successful. The ECC Protection table below shows the ECC protection scheme used throughout a page. With internal ECC, the user must accommodate the following: • Spare area definitions provided in the ECC Protection table below. • ECC can protect according main and spare areas. WRITEs to the ECC area are ignored. Table14-6. ECC Protection and Spare Area Min Byte Address Max Byte Address ECC Protected Area Description 000h 1FFh Yes Main 0 User data 0 200h 3FFh Yes Main 1 User data 1 400h 5FFh Yes Main 2 User data 2 600h 7FFh Yes Main 3 User data 3 800h 80Fh Yes Spare 0 User meta data 0(1) 810h 81Fh Yes Spare 1 User meta data 1 820h 82Fh Yes Spare 2 User meta data 2 830h 83Fh Yes Spare 3 User meta data 3 Note1:800H is reserved for initial bad block mark, and please check the initial bad block mark with internal ECC off. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |