DS3 datasheet(2/12 Pages) PENTAIR

2 / 12 page

Safety

READ AND FOLLOW

SAFETY INSTRUCTIONS!

This is the safety alert symbol. When you see this

symbol on your pump or in this manual, look for one of

the following signal words and be alert to the potential

for personal injury.

warns about hazards that will cause serious

personal injury, death or major property damage if

ignored.

warns about hazards that can cause serious

personal injury, death or major property damage if

ignored.

warns about hazards that will or can cause

minor personal injury or property damage if ignored.

The label NOTICE indicates special instructions which

are important but not related to hazards.

Carefully read and follow all safety instructions in this

manual and on pump.

Keep safety labels in good condition.

Replace missing or damaged safety labels.

California Proposition 65 Warning

This product and related accessories contain

chemicals known to the State of California to cause

cancer, birth defects or other reproductive harm.

GENERAL SAFETY

Do not touch an operating motor. Modern

motors can operate at high temperatures. To avoid burns

when servicing pump, allow it to cool for 20 minutes

after shut-down before handling.

Pump is designed as a lawn sprinkler only. To avoid heat

built-up, over pressure hazard and possible injury, do not

use in a pressure tank (domestic water) system. Do not use

as a booster pump; pressurized suction may cause pump

body to explode.

Do not allow pump or piping system to freeze. Freezing

can damage pump and pipe, may lead to injury from

equipment failure and will void warranty.

Pump water only with this pump.

Periodically inspect pump and system components.

Wear safety glasses at all times when working on pumps.

Keep work area clean, uncluttered and properly lighted;

store properly all unused tools and equipment.

Keep visitors at a safe distance from the work areas.

Make workshops childproof; use padlocks and master

switches; remove starter keys.

WARNING

Hazardous pressure!

Install pressure relief

valve in discharge pipe.

Release all pressure on

system before working on

any component.

WARNING

Hazardous voltage.

Can shock, burn, or

cause death.

Ground pump before

connecting to power

supply.

Wire motor for

correct voltage.

See “Electrical” section of

this manual and motor

nameplate.

Ground motor before

connecting to power

supply.

Meet National

Electrical Code,

Canadian Electrical Code, and

local codes for all wiring.

Follow wiring

instructions in this

manual when connecting

motor to power lines.

ELECTRICAL SAFETY

DS3 bảng dữ liệu(PDF) 2 Page - Pentair plc. All rights reserved.

DS3 bảng dữ liệu(HTML) 2 Page - Pentair plc. All rights reserved.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

bảng dữ liệu tải về

Link URL