4

Product Specification

M270DTN01.5

1. Handling Precautions

1. Since front polarizer is easily damaged, pay attention not to scratch it.

2. Be sure to turn off power supply when inserting or disconnecting from input connector.

3. Wipe off water drop immediately. Long contact with water may cause discoloration or spots.

4. When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.

5. Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.

6. Since CMOS LSI is used in this module, take care of static electricity and insure human earth when

handling.

7. Do not open or modify the Module Assembly.

8. Do not press the reflector sheet at the back of the module to any directions.

9. In case if a Module has to be put back into the packing container slot after once it was taken out from the

container, do not press the center of the LED lightbar edge. Instead, press at the far ends of the LED light

bar edge softly. Otherwise the TFT Module may be damaged.

10. At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the

Interface Connector of the TFT Module.

11. After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module even

momentary. At designing the enclosure, it should be taken into consideration that no bending/twisting

forces are applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.

12. Small amount of materials having no flammability grade is used in the LCD module. The LCD module

should be supplied by power complied with requirements of Limited Power Source (IEC60950 or

UL1950), or be applied exemption.

13. Please avoid touching COF Position while you are doing mechanical design.

14.When storing modules as spares for a long time, the following precaution is necessary:

a. Store them in a dark place. Do not expose the module to sunlight or fluorescent light.

b. Keep the temperature between 5℃ and 35℃ at normal humidity.