AP6503

Document number: DS35077 Rev. 7 - 2

10 of 16

www.diodes.com

May 2017

© Diodes Incorporated

AP6503

Undervoltage Lockout (UVLO)

Undervoltage Lockout is implemented to prevent the IC from insufficient input voltages. The AP6503 has a UVLO comparator that monitors the

input voltage and the internal bandgap reference. If the input voltage falls below 4.0V, the AP6503 will disable. In this event, both HS and LS

MOSFETs are turned off.

Overvoltage Protection

When the AP6503 FB pin exceeds 20% of the nominal regulation voltage of 0.925V, the over voltage comparator is tripped and the COMP pin

and the SS pin are discharged to GND, forcing the high-side switch off.

Thermal Shutdown

The AP6503 has on-chip thermal protection that prevents damage to the IC when the die temperature exceeds safe margins. It implements a

thermal sensing to monitor the operating junction temperature of the IC. Once the die temperature rises to approximately +160°C, the thermal

protection feature gets activated. The internal thermal sense circuitry turns the IC off thus preventing the power switch from damage.

A hysteresis in the thermal sense circuit allows the device to cool down to approximately +120°C before the IC is enabled again through soft

start. This thermal hysteresis feature prevents undesirable oscillations of the thermal protection circuit.

Setting the Output Voltage

The output voltage can be adjusted from 0.925V to 20V using an external resistor divider. Table 1 shows a list of resistor selection for common

output voltages. Resistor R1 is selected based on a design tradeoff between efficiency and output voltage accuracy. For high values of R1 there

is less current consumption in the feedback network. However the trade off is output voltage accuracy due to the bias current in the error

amplifier. R1 can be determined by the following equation:



















1

0.925

V

R

R

OUT

2

1

Vout

FB

R1

R2

Figure 6 Feedback Divider Network

When output voltage is low, network as shown in

Figure is recommended.

R1(KΩ)

R2(KΩ)

1.2

3

10

1.8

9.53

10

2.5

16.9

10

3.3

26.1

10

5

45.3

10

Table 1