AP6502

Document Number: DS35423 Rev. 10- 2

12 of 14

www.diodes.com

May 2017

© Diodes Incorporated

AP6502

PC Board Layout

This is a high switching frequency converter. Hence attention must be paid to the switching currents interference in the layout. Switching current

from one power device to another can generate voltage transients across the impedances of the interconnecting bond wires and circuit traces.

These interconnecting impedances should be minimized by using wide, short printed circuit traces.

52mm

External feedback resistor

dividers must be placed

close to the FB

Input capacitor C1must be placed as

close as possible to the IC and to L1

AP6502SP-13 is exposed at the bottom of the package and must be soldered directly to a well designed thermal pad on the PCB. This will

help to increase the power dissipation. This is not applicable for the AP6502S-13.

External Bootstrap Diode

It is recommended that an external bootstrap diode be added when the input voltage is no greater than 5V or the 5V rail is available in the

system. This helps to improve the efficiency of the regulator. This solution is also applicable for D > 65%. The bootstrap diode can be a low

cost one such as B130 or a Schottky that has a low Vf.

AP6502

BST

SW

10nF

BOOST

DIODE

5V

4

3

Figure 4

—External Bootstrap

Compensation Components

Recommended Diodes:

Part Number

Voltage/Current Rating

Vendor

B130

30V, 1A

Diodes Incorporated

SK13

30V, 1A

Diodes Incorporated