174

051718

F72/F75 Series

Low Profile and HiCV Conformal Coated Chip

TEST

F72/75 series (Temperature range -55ºC to +125ºC)

Condition

At 40°C, 90 to 95% R.H., 500 hours (No voltage applied)

Capacitance Change ........... Refer to page 173 (*1)

Dissipation Factor ................ Initial specified value or less

Leakage Current .................. Initial specified value or less

At -55°C / +125°C, 30 minutes each, 5 cycles

Capacitance Change ........... Refer to page 173 (*1)

Dissipation Factor ................ Initial specified value or less

Leakage Current .................. Initial specified value or less

10 seconds reflow at 260°C, 10 seconds immersion at 260°C.

Capacitance Change ........... Refer to page 173 (*1)

Dissipation Factor ................ Initial specified value or less

Leakage Current .................. Initial specified value or less

After application of surge voltage in series with a 33Ω resistor at the rate of 30 seconds ON, 30 seconds OFF,

for 1000 successive test cycles at 85ºC, capacitors shall meet the characteristic requirements in the table above.

Capacitance Change ........... Refer to page 173 (*1)

Dissipation Factor ................ Initial specified value or less

Leakage Current .................. Initial specified value or less

After 2000 hours’ application of rated voltage at 85°C,

capacitors shall meet the characteristic requirements in the table above.

Capacitance Change ........... Refer to page 173 (*1)

Dissipation Factor ................ Initial specified value or less

Leakage Current .................. Initial specified value or less

After applying the pressure load of 5N for 10±1 seconds horizontally to the center of capacitor side body

which has no electrode and has been soldered beforehand on a substrate, there shall be found neither

exfoliation nor its sign at the terminal electrode.

Keeping a capacitor surface-mounted on a substrate upside down and supporting the substrate at

both of the opposite bottom points 45mm apart from the center of capacitor, the pressure strength is

applied with a specified jig at the center of substrate so that the substrate may bend by 1mm as

illustrated. Then, there shall be found no remarkable abnormality on the capacitor terminals.

QUALIFICATION TABLE

Damp Heat

(Steady State)

Temperature Cycles

Resistance to

Soldering Heat

Surge

Endurance

Shear Test

Terminal Strength