6390 datasheet(13/17 Pages) PHOENIX

13 / 17 page

IB IL INC-IN ...

6390_en_07

PHOENIX CONTACT

Connection example

Figure 8

Typical connection with 24 V DC encoder

supply

Key

Connection notes

Programming data/

configuration data

11.1

Local bus (INTERBUS)

11.2

Other bus systems

Encoder/incremental encoder

6390B005

INC-IN

24V

I 2

I 1

I 3

A, A

B, B

Z, Z

–

GND

Encoders should always be connected using

shielded twisted pair cables. Unshielded cables

may lead to erroneous results in environments

with heavy noise. On the terminal side, the shield

is capacitively connected to functional earth

ground (FE) via the shield connector. On the

encoder side, the shield must be connected with

the grounded encoder housing.

If the encoder does not have a shield connection,

the shield can also be directly connected in the

control cabinet to functional earth ground via an

additional shield connection clamp.

For information on shielding and connecting

shielded cables, please refer to the

IB IL SYS PRO UM E user manual or the Inline

system manual for your bus system.

Please also observe the manufacturer's

installation instructions for the incremental

encoder.

ID code

hex (127dec)

Length code

hex

Process data channel

32 bits

Input address area

2 words

Output address area

2 words

Parameter channel (PCP)

0 bytes

2 words

For the configuration data of other bus systems,

please refer to the corresponding electronic

device data sheet (e.g., GSD, EDS).

6390 bảng dữ liệu(PDF) 13 Page - PHOENIX CONTACT

6390 bảng dữ liệu(HTML) 13 Page - PHOENIX CONTACT

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

bảng dữ liệu tải về

Link URL