PCF7941ATJ datasheet(9/18 Pages) NXP

9 / 18 page

NXP Semiconductors

Product Specification

Security Transponder and RISC Controller (STARC 2XLite)

PCF7x41ATJ

2013 Oct 15

CONFIDENTIAL

FUNCTIONAL DESCRIPTION

The PCF7x41ATJ incorporates Security Transponder and

Remote Keyless Entry features that are specified in detail

by the data sheet PCF7x41 and the corresponding ROM

Library Description; see section 13.

8.1 LF Field Power On Reset

When the transponder enters a LF Field a rectifier circuitry

becomes operational and the rectified voltage develops.

The LF Field has to be present for at least 2ms (tFLD,HLD)

before this supply voltage is passed on to become the

transponder supply voltage (VDDC). As soon as the supply

voltage (VDDC) exceeds the LF Field Power-On Reset

threshold voltage (VPOR,FLD) the device performs a chip

reset and starts its initialization sequence by executing its

boot routine, see Figure 4.

LF Field applied

BTHR

tFLD,HLD

VDDC

VPOR,FLD

Invocation of device

BOOT Routine

tPOR-HLD

tSTART

LF Field applied

BTHR

tFLD,HLD

VDDC

VPOR,FLD

Invocation of device

BOOT Routine

tPOR-HLD

tSTART

Figure 4 LF field power on reset timing

Subsequently, the transponder is muted and does not

respond to any command until termination of the device

boot sequence. The startup time, tSTART, depends on the

base station configuration, the resonance circuit properties

and

the

system

coupling

factor,

however,

small

compared with the LF Field hold time (tFLD,HLD).

Regardless of the supply condition, once the supply voltage

(VDD) exceeds the Power On Reset threshold voltage

(VPOR,BAT respectively VPOR,FLD), POR becomes low.

After a short delay (TPOR,HLD), the flip-flop is forced into

latch state freezing the supply switch state and the RISC

Controller

becomes

operational.

Program

execution

commences starting with the BOOT Routine, before the

application Program or Transponder Emulation is being

invoked, see Figure 5

VPOR,FLD

VPOR,BAT

tBOOT

Invocation of:

- Application Program or

- Transponder Emulation

Invocation of

BOOT Routine

tPOR-HLD

Figure 5 Power-up timing

In order to force a LF Field Power-On Reset and proper

device initialization at any time, the LF field OFF condition

must be applied for at least tRESET,SETUP, in order to ensure

that the INTERNAL device supply voltage, VDDc, drops

below the threshold voltage (VPOR,FLD), see Figure 6.

LF field OFF

VPOR,FLD

VDDC

tRESET_SETUP

LF field power on reset (POR)

threshold voltage

LF field OFF

VPOR,FLD

VDDC

tRESET_SETUP

LF field power on reset (POR)

threshold voltage

Figure 6 LF field power on reset setup timing

PCF7941ATJ bảng dữ liệu(PDF) 9 Page - NXP Semiconductors

PCF7941ATJ bảng dữ liệu(HTML) 9 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

bảng dữ liệu tải về

Link URL