LifecyclePhase:

Revision

: 1

Expired Period: Forever

Release Date:2014-08-04 14:16:36.0

DATASHEET

SMD  B

EAST2012YA0-AM

DSE-0011808

www.everlightamericas.com

(B) Recommend soldering pad

Note: Tolerances unless mentioned ±0.1mm. Unit = mm

2. Current limiting

A resistor should be used to limit current spikes that can be caused by voltage fluctuations. Otherwise

damage could occur.

3. Storage

3.1 Do not open moisture proof bag before the products are ready to use.

3.2 After opening the package: The LEDs should be kept at 30℃ or less and 60%RH or less.

3.3 The LEDs should be used within 168 hours (7days) after opening the package .

If unused LEDs remain, it should be stored in moisture proof packages.

3.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the

storage time, baking treatment should be performed using the following conditions.

Baking treatment : 60±5℃ for 24 hours.

4. Iron Soldering

Hand soldering is not recommended for regular production. These guidelines are for rework only. Soldering

iron tip should contact each terminal no more than 3 sec at 350℃, using soldering iron with nominal power

less than 25W. Allow min. 2 sec. between soldering intervals.

5. Usage

Do not exceed the values given in this specification.