| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
USB375X bảng dữ liệu(PDF) 27 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
USB375X bảng dữ liệu(HTML) 27 Page - Microchip Technology |
|
27 / 31 page ![]() 2011 - 2014 Microchip Technology Inc. DS00001824A-page 27 USB375x APPENDIX A: DATA SHEET REVISION HISTORY TABLE A-1: REVISION HISTORY Revision Section/Figure/Entry Correction DS00001824A (09-22-14) Replaces previous SMSC version Rev. 1.1 (02-12-13); document is converted to Microchip template Product Identification Sys- tem on page 29 Reel size is changed from 4000 to 5000; tempera- ture range designator and explanation removed Package Information on page 25 The following diagrams removed: Reel Dimen- sions, Tape Sections and Package Marking. Section 2.2, "Pin Definitions" Description for pins 12 and 13 modified. All Updated Battery Charging references to revision 1.2 of the specification. Section 1.0, "Introduction," on page 4 • Added note: “The device’s Data Contact Detect Timeout parameter does not conform to the USB Battery Charging Specification. How- ever, this will not affect other factors in charger detection. Refer to Table 3-2, “Electrical Speci- fications,” on page 7 for additional informa- tion.” • Added cross-references to new note on all mentions of the Battery Charging Specification in this section. Table 3-2, “Electrical Specifi- cations,” on page 7 • Updated VBUS Over Voltage Lockout values to be specific for the USB3750 and USB3751 • Updated Data Contact Detect Timeout values and added note: The device’s Data Contact Detect Timeout parameter does not conform to the USB Battery Charging Specification. How- ever, this will not affect other factors in charger detection.” Rev. 1.1 (02-12-13) All Misc. typos, etc. Section 4.4.1, "I2C Interface," on page 18 Added additional paragraph: “The USB375x-1 requires I2C communications in order for the default USB path to be enabled. By default, the 100mA current limit is enabled. Only devices that draw <100mA will be enabled through the path as part of dead battery provision support. In order to bypass this limit, bits 0 (EnableOVP Switch) and 2 (OverideVBUS) in Register 1 (Configuration Register) need to be set via I2C.” Rev. 1.0 (09-02-11) Initial Release |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |