EV3336-C-00A- DUAL-CHANNEL FLASH LED DIRVER WITH I

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV3366-C-00A Rev.1.0

www.MonolithicPower.com

7

2/2/2016

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2016 MPS. All Rights Reserved.

QUICK START GUIDE

1. Connect the positive and negative terminals of the power supply (2.7V ~ 5.5V) to the VIN and GND

pins on the EV board, respectively.

2. Supply the EN terminal with logical signal.

3. Connect the positive and negative terminals of the LED to the LED1/2 pin and GND on the EV

board, respectively.

4. Please connect SCL, SDA and GND of EV board to SCL, SDA and GND of a programmable kit

5. When work in Torch mode, please pull torch terminal to high. When work in flash mode with

hardware trigger mode, please give a level or pulse signal to STR pin.