MP3910 datasheet(2/23 Pages) MPS

2 / 23 page

MP3910 –PEAK CURRENT MODE BOOST CONTROLLER

MP3910 Rev. 1.11

www.MonolithicPower.com

11/6/2014

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

ORDERING INFORMATION

Part Number*

Package

Top Marking

MP3910GK

MSOP10

M3910

* For Tape & Reel, add suffix –Z (e.g. MP3910GK–Z);

PACKAGE REFERENCE

COMP

GND

VCC

GATE

EN/SYNC

VIN

TOP VIEW

ISENSE

ABSOLUTE MAXIMUM RATINGS

(2)

VIN to GND.....................................-0.3V to 40V

VCC, GATE to GND.......................–0.3V to 15V

All Other Pins...................................–0.3V to 6V

EN Pin Sink Current.............................. 0.5mA(6)

Continuous Power Dissipation (TA = +25°C)

(3)

........................................................... 0.83W

Maximum Operating Frequency............. 500kHz

Storage Temperature............... -55°C to +150°C

Junction Temperature...............................150°C

Lead Temperature ....................................260°C

Recommended Operating Conditions

(4)

Supply Voltage VIN ..............................7V to 35V

Supply Voltage with VIN and VCC connected

......................................................5V to 13V

EN Pin Sink Current.................. 0mA to 0.4mA(5)

Operating Junction Temp. (TJ). -40°C to +125°C

Thermal Resistance

(5)

θJA

θJC

MSOP10 ................................ 150 ..... 65... °C/W

Notes:

2) Exceeding these ratings may damage the device.

3) The maximum allowable power dissipation is a function of the

maximum junction temperature TJ (MAX), the junction-to-

ambient thermal resistance θJA, and the ambient temperature

TA. The maximum allowable continuous power dissipation at

any ambient temperature is calculated by PD (MAX) = (TJ

(MAX)-TA)/θJA. Exceeding the maximum allowable power

dissipation will cause excessive die temperature, and the

regulator will go into thermal shutdown. Internal thermal

shutdown circuitry protects the device from permanent

damage.

4) The device is not guaranteed to function outside of its

operating conditions.

5) Measured on JESD51-7, 4-layer PCB.

6) Refer to “Enable/SYNC Control” section.

MP3910 bảng dữ liệu(PDF) 2 Page - Monolithic Power Systems

MP3910 bảng dữ liệu(HTML) 2 Page - Monolithic Power Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

bảng dữ liệu tải về

Link URL