OP232W datasheet(3/6 Pages) TTELEC

3 / 6 page

General Note

TT Electronics reserves the right to make changes in product speciﬁcation without notice or

liability. All information is subject to TT Electronics’ own data and is considered accurate at

time of going to print.

Hermetic Infrared Emitting Diode

OP230 Series

Issue B

07/2016

Page 3

OPTEK Technology, Inc.

1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200

www.optekinc.com | www.ttelectronics.com

Notes:

1. RMA ﬂux is recommended. Dura on can be extended to 10 seconds maximum when ﬂow soldering.

2. Derate linearly 2.0 mW/° C above 25° C.

3. Measurement made with 100 µs pulse measured at the trailing edge of the pulse with a duty cycle of 0.1% and an IF = 100 mA.

4. For the OP231 series, EE(APT) is a measurement of the average radiant intensity within the cone formed by the measurement surface, a radius of

1.429” (36.30 mm) measured from the lens side of the tab to the sensing surface and a sensing surface of 0.250” (6.35 mm) in diameter forming a 10°

cone. For the OP231W series, EE(APT) is a measurement of the average radiant intensity within the cone formed by the measurement surface, a radius

of 0.466” (11.84 mm) measured from the lens side of the tab to the sensing surface and a sensing surface of 0.250” (6.35 mm) in diameter forming a

10° cone. EE(APT) is not necessarily uniform within the measured area.

Electrical Characteris cs (TA = 25°C unless otherwise noted)

SYMBOL

PARAMETER

MIN

TYP

MAX UNITS

TEST CONDITIONS

Input Diode

Apertured Radiant Incidence

OP231

OP232

OP233

OP234

OP235

1.5

2.0

3.0

5.0

6.0

‐

6.0

‐

mW/

OP231 Series

IF = 100 mA

(3 )(4)

Aperture = 0.250”

Distance = 1.429”

OP231W

OP232W

OP233W

OP234W

OP235W

1.5

3.5

5.0

6.0

‐

7.0

‐

mW/

OP231W Series

IF = 100 mA

(3 )(4)

Aperture = 0.250”

Distance = 0.466”

Radiant Power Output

OP231

OP232

OP233

‐

6.0

8.0

10.0

‐

IF = 100 mA

(3 )(4)

Forward Voltage

‐

2.0

IF = 100 mA

(3)

Reverse Current

‐

100

µA

VR= 2.0 V

λP

Wavelength at Peak Emission

OP231, OP232, OP233

OP234, OP235

‐

890

850

‐

IF = 10 mA

Spectral Bandwidth between Half Power

Points

‐

IF = 10 mA

∆λP /∆T

Spectral Shi with Temperature

‐

+0.30

‐

nm/°C IF = Constant

θHP

Emission Angle at Half Power Points

OP231 ‐ OP235

OP231W ‐ OP231W

‐

Degree IF = 100 mA

Output Rise Time

‐

500

‐

IF(PK)=100 mA, PW=10 µs, and

D.C.=10.0%

Output Fall Time

‐

250

‐

EE(APTa)

OP232W bảng dữ liệu(PDF) 3 Page - TT Electronics.

OP232W bảng dữ liệu(HTML) 3 Page - TT Electronics.

Html Pages

1 2 3 4 5 6

bảng dữ liệu tải về

Link URL