www.micropowerdirect.com

Model

Number

Input

Output

Efficiency

(%, Typ)

Over

Voltage

Protection

(VDC Typ)

Capacitive

Load

(µF, Max)

Fuse Rating

Slow-Blow

(mA)

Voltage

(VDC)

Current

(mA, Max)

Current

(mA, Min

)

Nominal

Range

MPV4080S-12RHI

800

200 - 1500

12.0

3,330

0.0

76

20.0

3,000

15A/1,500 VDC

MPV4080S-15RHI

800

200 - 1500

15.0

2,670

0.0

78

20.0

1,500

15A/1,500 VDC

MPV4080S-24RHI

800

200 - 1500

24.0

1,670

0.0

80

30.0

680

15A/1,500 VDC

Notes:

1. To meet the specified ripple and noise levels, external capacitors are required. See the typical connection information on page three for recommended values. For more information, please

contact the factory.

2. All units will meet EN 55022 (CE/RE) class A with the input circuit shown in the “Typical Connection 2” diagram on page 3. Contact the factory for more information.

3. All units will meet EN 61000-4-4 (±2 kV) with the input circuit shown in the “Typical Connection 2” diagram on page 3. Contact the factory for more information.

4. All units will meet the requirements of EN 61000-4-5 (±1 kV), with the input circuit shown in the “Typical Connection 2” diagram on page 3. Contact the factory for more information.

5. Lead temperature is measured 1.5 mm from the case.

6. Operation at no load will not damage the units, however, they may not meet all specifications.

7. It is recommended that a fuse be used on the input of a power supply for protection. For the MPV4080-xxRHI series, a 15A/1,500 VDC slow blow should be used.

Model Selection Guide

Derating Curve: Altitude