CP10.241-R1, CP10.241-R2,

CP10.241-R3,CP10.242-R2

CP-Series

Feb. 2018 / CP10.241-R2 Rev0.3-EN - All values are typical figures specified at 230Vac, 50Hz input voltage, 24V, 10A output

load, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

19/31

P R E L I M I N A R Y

Isolation resistance

Min.

500MOhm

At delivered condition between input and output,

measured with 500Vdc

Min.

500MOhm

At delivered condition between input and PE,

measured with 500Vdc

Min.

500MOhm

At delivered condition between output and PE,

measured with 500Vdc

Min.

500MOhm

At delivered condition between output and DC-OK

contacts, measured with 500Vdc

PE resistance

Max.

0.1Ohm

Resistance between PE terminal and the housing in

the area of the DIN-rail mounting bracket.

Typ.

30.5Vdc

Max.

32Vdc

Class of protection

I

According to IEC 61140

Degree of protection

IP 20

According to EN/IEC 60529

Included

Output shut-down with automatic restart.

Input transient protection

MOV

(Metal Oxide Varistor)

For protection values see chapter 16 (EMC).

Internal input fuse

Included

Not user replaceable slow-blow high-braking

capacity fuse

Touch current (leakage current)

Typ.

0.14mA / 0.36mA

At 100Vac, 50Hz, TN-,TT-mains / IT-mains

Typ.

0.20mA / 0.50mA

At 120Vac, 60Hz, TN-,TT-mains / IT-mains

Typ.

0.33mA / 0.86mA

At 230Vac, 50Hz, TN-,TT-mains / IT-mains

Max.

0.18mA / 0.43mA

At 110Vac, 50Hz, TN-,TT-mains / IT-mains

Max.

0.26mA / 0.61mA

At 132Vac, 60Hz, TN-,TT-mains / IT-mains

Max.

0.44mA / 1.05mA

At 264Vac, 50Hz, TN-,TT-mains / IT-mains

1) In case of an internal defect, a redundant circuit limits the maximum output voltage. The output shuts down and automatically attempts to

restart.

2) Temperature sensors are installed on critical components inside the unit and turn the unit off in safety critical situations, which can happen

e.g. when ambient temperature is too high, ventilation is obstructed or the de-rating requirements are not followed. There is no correlation

between the operating temperature and turn-off temperature since this is dependent on input voltage, load and installation methods.