PI5C16233C datasheet(2/3 Pages) PERICOM

2 / 3 page

PS8361A

06/28/99

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

PI5C16233C

16-Bit to 32-Bit Mux/Demux BusSwitch

with Undershoot Protection

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the

lower of the voltages on the two (A,B) pins.

4. This parameter is determined by device characterization but is not production tested.

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(4)

Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

CON

A/B Capacitance, Switch On

VIN = 0V

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Storage Temperature ..................................................... –65°C to +150°C

Ambient Temperature with Power Applied .................... –40°C to +85°C

Supply Voltage Range ........................................................ –0.5V to +7V

DC Input Voltage ............................................................... –0.5V to +7V

DC Output Current ....................................................................... 120mA

Power Dissipation ............................................................................. 0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device.

This is a stress rating only and functional operation of the

device at these or any other conditions above those indi-

cated in the operational sections of this specification is not

implied. Exposure to absolute maximum rating conditions

for extended periods may affect reliability.

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, V

CC = 4.5V to 5.5V)

Parameters

Description

Test Conditions(1)

Min. Typ.(2) Max.

Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

µA

IOZH

High Impedance Output Current

≤ A, B ≤ V

±1

µA

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–0.7

–1.8

RON

Switch On Resistance(3)

VCC = Min., VIN = 0.0V, ION = 48mA or 64mA

Ω

VCC = 4.0V, VIN = 2.4V, ION = 15mA

PI5C16233C bảng dữ liệu(PDF) 2 Page - Pericom Semiconductor Corporation

PI5C16233C bảng dữ liệu(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3

bảng dữ liệu tải về

Link URL