Gain Control Interface (GAIN)

10 MHz

Gain Range ...................................................................................................................................... 45 dB

Maximum Gain (GAIN = 950 mV) ............................................................................................... +42.5 dB

Minimum Gain (GAIN = 50 mV) ..................................................................................................... -2.5 dB

Scaling Factor (MODE = HI, 50 mV < GAIN < 950 mV)........................................................... +20 mV/dB

Scaling Factor (MODE = LO, 50 mV < GAIN < 950 mV)........................................................... -20 mV/dB

Gain Law Conformance ................................................................................................................. ±0.2 dB

GAIN Step Response from 0 dB to 30 dB ....................................................................................... 300 ns

GAIN Step Response from 30 dB to 0 dB ....................................................................................... 300 ns

140 MHz

Maximum Gain

……………………................................................................................................ +43.5 dB

Minimum Gain …………………. ..................................................................................................... -3.6 dB

Gain Scaling Factor

………………………………………………................................................. 19.7 mV/dB

Gain Intercept

………….................................................................................................................. -5.3 dB

Noise Figure (Maximum Gain)…………........................................................................................... 7.4 dB

190 MHz

Maximum Gain ……………………................................................................................................ +43.5 dB

Minimum Gain …………………. ..................................................................................................... -3.8 dB

Gain Scaling Factor………………………………………………................................................. 19.6 mV/dB

Gain Intercept ………….................................................................................................................. -5.3 dB

Noise Figure (Maximum Gain)…………........................................................................................... 7.5 dB

NOTES

1/ Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only; functional

operation of the device at these or any other conditions outside of those indicated in the operation sections of this specification is not implied. Exposure

to absolute maximum ratings for extended periods may affect device reliability.

2/ Measurement taken under absolute worst case condition and represents data taken with a thermal camera for highest power density location. See

MIL-STD-1835 for average package Theta JC numbers.