STM8S001J3 datasheet(40/84 Pages) STMICROELECTRONICS

40 / 84 page

Electrical characteristics

STM8S001J3

40/84

DocID030584 Rev 2

Figure 6. Pin input voltage

9.2

Absolute maximum ratings

Stresses above the absolute maximum ratings listed in Table 14: Voltage characteristics,

Table 15: Current characteristics, and Table 16: Thermal characteristics may cause

permanent damage to the device. These are stress ratings only and functional operation of

the device at these conditions is not implied. Exposure to maximum rating conditions for

extended periods may affect device reliability.

Device mission profile (application conditions) is compliant with JEDEC JESD47

Qualification Standard, extended mission profiles are available on demand.

VIN

STM8 pin

Table 14. Voltage characteristics

Symbol

Ratings

Min

Max

Unit

VDDx - VSS Supply voltage(1)

1. All power (VDD) and ground (VSS) pins must always be connected to the external power supply

-0.3

6.5

VIN

Input voltage on true open drain pins(2)

2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,

there is no positive injection current, and the corresponding VIN maximum must always be respected

VSS - 0.3

6.5

Input voltage on any other pin(2)

VSS - 0.3

VDD + 0.3

VESD

Electrostatic discharge voltage

see Absolute maximum

ratings (electrical

sensitivity) on page 74

STM8S001J3 bảng dữ liệu(PDF) 40 Page - STMicroelectronics

STM8S001J3 bảng dữ liệu(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

bảng dữ liệu tải về

Link URL