LMH6574 datasheet(4/15 Pages) NSC

4 / 15 page

±3.3V Electrical Characteristics (Continued)

S = ±3.3V, RL = 100

Ω,A

V=2 V/V; Unless otherwise specified.

Symbol

Parameter

Conditions (Note 2)

Min

Typ

Max

Units

IBN

Input Bias Current (Note 7)

IN =0V

-3

µA

PSRR

Power Supply Rejection Ratio

DC, Input Referred

ICC

Supply Current

No Load

VIH

Logic High Threshold

Select & Enable Pins (SD & EN)

1.3

VIL

Logic Low Threshold

Select & Enable Pins (SD & EN)

0.4

Miscellaneous Performance

RIN+

Input Resistance

Ω

CIN

Input Capacitance

0.8

ROUT

Output Resistance

0.06

Ω

Output Voltage Range

No Load

±2V

VOL

L = 100

Ω

±1.8

CMIR

Input Voltage Range

±1.2

Linear Output Current

IN =0V

±60

ISC

Short Circuit Current

IN = ±1V, Output shorted to

ground

±150

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is

intended to be functional, but specific performance is not guaranteed. For guaranteed specifications, see the Electrical Characteristics tables.

Note 2: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of

the device such that TJ =TA. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self heating where TJ > TA.

See Applications Section for information on temperature de-rating of this device. Min/Max ratings are based on product testing, characterization and simulation.

Individual parameters are tested as noted.

Note 3: The maximum output current (IOUT) is determined by the device power dissipation limitations (The junction temperature cannot be allowed to exceed

150˚C). See the Power Dissipation section of the Application Section for more details. A short circuit condition should be limited to 5 seconds or less.

Note 4: Human Body model, 1.5k

Ω in series with 100pF. Machine model, 0Ω In series with 200pF

Note 5: Parameters guaranteed by electrical testing at 25˚C.

Note 6: Parameters guaranteed by design.

Note 7: Positive Value is current into device.

LMH6574 bảng dữ liệu(PDF) 4 Page - National Semiconductor (TI)

LMH6574 bảng dữ liệu(HTML) 4 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

bảng dữ liệu tải về

Link URL