1FEATURES
2· Qualified for Automotive Applications
· ESD Protection Exceeds 2000 V Per
MIL-STD-883, Method 3015; Exceeds 200 V
Using Machine Model (C = 200 pF, R = 0)
· Modulation Scheme Optimized to Operate
Without a Filter
· Extremely Efficient Third-Generation 5-V
Class-D Technology:
– Low Supply Current (No Filter) . . . 4 mA
– Low Supply Current (Filter) . . . 7.5 mA
– Low Shutdown Current . . . 0.05 mA
– Low-Noise Floor . . . 40 mVRMS
(No-Weighting Filter)
– Maximum Efficiency Into 8 Ω, 75 – 85%
– Four Internal Gain Settings . . . 6 – 23.5 dB
– PSSR . . . –77 dB
· 4 mm × 4 mm MicroStar™ Junior BGA and
TSSOP Package Options
· 2 W Into a 4-Ω Speaker (THD+N<1%)
· <0.2% THD+N at 1.5 W, 1 kHz, Into a 4-Ω Load
· Integrated Depop Circuitry
· Short-Circuit Protection (Short to PVDD,
Ground, and Load)

DESCRIPTION/ORDERING INFORMATION
The TPA2000D1 is a 2-W mono bridge-tied-load (BTL) class-D amplifier designed to drive a speaker with at least
4-Ω impedance. The amplifier uses Texas Instruments third-generation modulation technique, which results in
improved efficiency and SNR. It also allows the device to be connected directly to the speaker without the use of
the LC output filter commonly associated with class-D amplifiers (this results in EMI which must be shielded at
the system level). These features make the device ideal for use in devices where high efficiency is needed to
extend battery run time.
The gain of the amplifier is controlled by two input terminals, GAIN1 and GAIN0. This allows the amplifier to be
configured for a gain of 6, 12, 18, and 23.5 dB. The differential input terminals are high-impedance CMOS inputs
and can be used as summing nodes.
The class-D BTL amplifier includes depop circuitry to reduce the amount of turnon pop at power up and when
cycling SHUTDOWN.
The TPA2000D1 is available in the 16-pin TSSOP and MicroStar™ Junior BGA packages and drive 2 W of
continuous output power into a 4-Ω load. The TPA2000D1T operates over an ambient temperature range of
–40°C to 105°C.