GENERAL DESCRIPTION

The EN25P16 is a 16M-bit (2048K-byte) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.

The EN25P16 is designed to allow either single Sector at a time or full chip erase operation. The EN25P16 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector.

FEATURES

• Single power supply operation

   - Full voltage range: 2.7-3.6 volt

• 16 Mbit Serial Flash

   - 16 M-bit/2048 K-byte/8192 pages

   - 256 bytes per programmable page

• High performance

   - 75MHz clock rate

• Low power consumption

   - 5 mA typical active current

   - 1 μA typical power down current

• Uniform Sector Architecture:

   - Thirty two 64-Kbyte sectors

• Software and Hardware Write Protection:

   - Write Protect all or portion of memory via software

   - Enable/Disable protection with WP# pin

• High performance program/erase speed

   - Byte program time: 7µs typical

   - Page program time: 1.5ms typical

   - Sector erase time: 800ms typical

   - Chip erase time: 18 Seconds typical

• Minimum 100K endurance cycle

• Package Options

   - 8 pins SOP 200mil body width

   - 8 contact VDFN

   - 16 pin SOP 300mil body width

   - All Pb-free packages are RoHS compliant

• Commercial and industrial temperature Range