1 Features
• Single or dual H-bridge motor driver
– Drives One or two brushed-DC motors
– One stepper motor
– One or two thermoelectric coolers (TEC)
• 4.5 V to 65 V operating supply voltage range
• Low RDS(ON):
– 100 mΩ HS + LS (Dual H-Bridge)
– 50 mΩ HS + LS (Single H-Bridge)
• High output current capability:
– Dual H-Bridge (24 V, 25 °C):
• 8-A peak with DDW package
• 16-A peak with DDV package
– Single H-Bridge (24 V, 25 °C):
• 16-A peak with DDW package
• 32-A peak with DDV package
• Pin-to-pin compatible with:
– DRV8252: 48V, H-bridge motor driver
• Programmable interface of operation -
– Phase/Enable (PH/EN)
– PWM (IN/IN)
• Integrated current sense and regulation
– Current sensing for high-side MOSFETs
– Sense output (IPROPI) for each H-bridge
– ± 4 % sense accuracy at maximum current
• Separate logic supply voltage (VCC)
• Configurable off-Time PWM chopping
– 7, 16, 24 or 32 μs
• Programmable fault recovery method
• Supports 1.8-V, 3.3-V, 5.0-V logic inputs
• Low-current sleep mode (3 μA)
• Protection features
– VM undervoltage lockout (UVLO)
– Charge pump undervoltage (CPUV)
– Overcurrent protection (OCP)
– Thermal shutdown (OTSD)
– Fault condition output (nFAULT)

2 Applications
• Brushed DC Motors
• Factory Automation, Stepper Drives and Robotics
• Medical Imaging, Diagnostics and Equipment
• ATMs, currency counters, and EPOS
• TEC Drivers

3 Description
The DRV8262 is a wide-voltage, high-power, Hbridge
motor driver for a wide variety of industrial
applications. The device integrates two H-bridges to
drive two DC motors or a bipolar stepper motor. The
H-bridges can be paralleled to drive one DC motor
with higher current. The DRV8262 supports up to
16-A peak current in the dual H-bridge mode and
up to 32-A in the single H-bridge mode. The device
also integrates current sensing and regulation, current
sense output and protection circuitry.
Integrated current sensing across the high-side
MOSFETs allows the driver to regulate the motor
current during startup and high load events. A current
limit can be set with an adjustable external voltage
reference. Additionally, the device provides output
current proportional to the motor current for each Hbridge.
The integrated sensing uses a current mirror,
removing the need for large shunt resistors, saving
board area and reducing system cost.
A low-power sleep mode is provided to achieve ultralow
quiescent current. Internal protection features are
provided for supply undervoltage lockout (UVLO),
charge pump undervoltage (CPUV), output over
current (OCP), and device overtemperature (OTSD).