1. General description
The 74ALVCH16374 is a 16-bit edge-triggered D-type flip-flop with bus hold inputs and 3-state
outputs. The device can be used as two 8-bit flip-flops or one 16-bit flip-flop. The device features
two clocks (1CP and 2CP) and two output enables (1OE and 2OE), each controlling 8-bits.
The flip-flops will store the state of their individual D-inputs that meet the set-up and hold time
requirements on the LOW-to-HIGH clock (nCP) transition. A HIGH on nOE causes the outputs
to assume a high-impedance OFF-state. Operation of the nOE input does not affect the state of
the flip-flops. This device is fully specified for partial power down applications using IOFF. The IOFF
circuitry disables the output, preventing the potentially damaging backflow current through the
device when it is powered down..
2. Features and benefits
• Wide supply voltage range from 1.2 V to 3.6 V
• Complies with JEDEC standards:
• JESD8-7 (1.65 V to 1.95 V)
• JESD8-5 (2.3 V to 2.7 V)
• JESD8C (2.7 V to 3.6 V)
• CMOS low power dissipation
• MULTIBYTE flow-through standard pin-out architecture
• Low inductance multiple VCC and GND pins for minimum noise and ground bounce
• Direct interface with TTL levels
• All data inputs have bus hold
• Latch-up performance exceeds 100 mA per JESD 78 Class II Level B
• Output drive capability 50 Ω transmission lines at 85 °C
• IOFF circuitry provides partial Power-down mode operation
• Current drive ±24 mA at VCC = 3.0 V
• ESD protection:
• HBM JESD22-A114F exceeds 2000 V
• MM JESD22-A115-B exceeds 200 V
• Specified from -40 °C to +85 °C