SE2620T-R
AI

## Overview of the SE2620T-R
The **SE2620T-R** is a highly integrated **Frontend Module (FEM)** specifically designed for Bluetooth and 802.11b/g/n WLAN applications. It is manufactured by Skyworks Solutions and is primarily used to optimize the signal path between the chipset and the antenna.
---
### 1. Key Internal Electronic Components
The device integrates several critical RF components into a single, compact package:
| Component | Function |
| :--- | :--- |
| **Power Amplifier (PA)** | Boosts the 2.4 GHz signal for transmission to meet range requirements. |
| **Low Noise Amplifier (LNA)** | Amplifies weak incoming signals while minimizing added noise to improve sensitivity. |
| **T/R Switch** | An internal Transmit/Receive switch that toggles the antenna between the PA and LNA. |
| **Power Detector** | Provides a closed-loop feedback mechanism to monitor and regulate output power. |
| **Harmonic Filter** | Suppresses unwanted frequencies to comply with FCC/CE emissions standards. |
---
### 2. Technical Specifications
The following table summarizes the primary electrical characteristics:
| Parameter | Typical Value |
| :--- | :--- |
| **Frequency Range** | 2400 MHz to 2500 MHz (2.4 GHz ISM Band) |
| **Supply Voltage (VCC)** | 2.7V to 4.8V |
| **Output Power (802.11g)** | +18 dBm @ 3% EVM |
| **Gain (Transmit Path)** | ~26 dB |
| **Noise Figure (Receive Path)** | ~2.5 dB |
| **Package Type** | QFN (20-pin, 3.0mm x 3.0mm x 0.9mm) |
---
### 3. Pin Configuration and Interface
The SE2620T-R uses a simplified interface to communicate with the Baseband/MAC processor:
* **RF_IN / RF_OUT:** High-frequency ports for the signal entering from the chipset and exiting to the antenna.
* **VCC:** Main power supply pins.
* **VEN / VDET:** Enable pins to power down the chip for energy saving and detector output for power leveling.
* **Logic Control:** Digital pins used to switch between Transmit (TX), Receive (RX), and Bluetooth (BT) modes.
---
### 4. Common Applications
Due to its small footprint and high efficiency, it is commonly found in:
* Smartphones and Tablets.
* PC Cards and USB Dongles.
* Access Points and Routers.
* Embedded Wi-Fi modules for IoT devices.
---
- ⤷What are the power consumption levels for SE2620T-R in sleep mode?
- ⤷ How does the SE2620T-R handle coexistence between Wi-Fi and Bluetooth?
- ⤷ What are the recommended PCB layout guidelines for this RF module?