công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

  • M93C46-RMB3TG/W

  • AI
    The **M93C46-RMB3TG/W** is a low-voltage, serial Microwire EEPROM (Electrically Erasable Programmable Memory) manufactured by STMicroelectronics. It is widely used for storing configuration data, user preferences, and calibration parameters in embedded systems. --- ## 1. Technical Specifications Below are the primary electrical and physical characteristics of the component: | Feature | Specification | | :--- | :--- | | **Memory Size** | 1 Kbit (1,024 bits) | | **Organization** | 64 x 16-bit or 128 x 8-bit (User selectable) | | **Interface** | Microwire (3-wire serial interface) | | **Supply Voltage (Vcc)** | 1.8V to 5.5V | | **Clock Frequency** | 2 MHz | | **Package Type** | UFDFPN8 (Ultra-thin Fine pitch Dual Flat No-lead) | | **Temperature Range** | -40°C to +125°C (Automotive Grade 3) | | **Data Retention** | > 40 Years | | **Write Cycles** | 4 Million cycles | --- ## 2. Pin Configuration The device typically uses an 8-pin layout. The functions of the pins are as follows: 1. **S (Chip Select):** Activates the device when high. 2. **D (Serial Data Input):** Receives opcodes, addresses, and data. 3. **Q (Serial Data Output):** Outputs data during read operations. 4. **C (Serial Clock):** Synchronizes data transfer. 5. **ORG (Organization):** Selects internal organization (High for x16, Low/GND for x8). 6. **Vcc/Vss:** Power supply and Ground. --- ## 3. Key Features * **Microwire Protocol:** Uses a simple synchronous serial bus. It is similar to SPI but uses a specific opcode-based communication style. * **Sequential Read:** Allows for reading the entire memory contents in a single continuous stream. * **Self-Timed Write Cycle:** Includes an internal control timer that manages the "Write" or "Erase" duration (typically 5ms). * **Ready/Busy Signal:** After a write command, the Data Out (Q) pin can be polled to check if the internal write cycle is complete. * **Low Power Consumption:** Optimized for battery-operated devices with low active and standby currents. --- ## 4. Part Number Breakdown * **M93C46:** Base part number (1 Kbit Microwire EEPROM). * **-R:** Operating voltage range (1.8V to 5.5V). * **MB:** Package code for UFDFPN8 (2x3 mm). * **3:** Temperature range (-40 to +125 °C). * **TG:** Tape & Reel packing with "Green" (RoHS compliant) materials. * **W:** Process technology/wafer identifier.
    ✨ Follow-up Questions
    • ⤷ How does the ORG pin change the memory addressing between 8-bit and 16-bit modes?
    • ⤷ What are the specific timing requirements for the 'Ready/Busy' polling on pin Q?
    • ⤷ Can this EEPROM be interfaced directly with a standard SPI controller?