M2REB-SD3-R2
AI

## Overview: M2REB-SD3-R2
The **M2REB-SD3-R2** is a specific model identifier typically associated with **M.2 to SD Card / MicroSD Card Adapters** or specialized expansion modules used in industrial computing and embedded systems. These parts allow an M.2 (NGFF) slot to act as an interface for high-speed storage via SD cards.
---
### Technical Specifications
The following table outlines the typical electronic characteristics of this component category:
| Parameter | Specification |
| :--- | :--- |
| **Interface Type** | M.2 (NGFF) Key B or Key B+M |
| **Supported Storage** | SD / SDHC / SDXC (UHS-I) |
| **Voltage Supply** | 3.3V (Standard M.2 rail) |
| **Controller** | Realtek or Genesys Logic Bridge Chip |
| **Data Transfer Rate** | Up to 104 MB/s (SDR104 mode) |
| **Form Factor** | M.2 2242 or 2230 |
| **Operating Temp** | -40°C to +85°C (Industrial Grade) |
---
### Electronic Components & Architecture
The circuitry of the M2REB-SD3-R2 generally consists of three primary functional blocks:
#### 1. The Bridge Controller
The heart of the module is an **integrated bridge chip** (often a PCIe-to-SD or USB-to-SD controller).
- It translates the PCIe or USB signals from the M.2 pins into the SD protocol.
- It manages error correction and wear leveling for the connected SD media.
#### 2. Power Management (PMIC)
Since SD cards require stable voltage to prevent data corruption, the board includes:
- **LDO Regulators:** To step down or stabilize the 3.3V from the M.2 slot.
- **Decoupling Capacitors:** Small SMD capacitors placed near the SD slot to filter high-frequency noise.
#### 3. Signal Protection
- **ESD Protection Diodes:** Located near the SD card entry point to protect the internal silicon from static electricity during card insertion.
- **Termination Resistors:** Used to match impedance and reduce signal reflections on high-speed data lines.
---
### Pinout and Connectivity
The M2REB-SD3-R2 utilizes the **M.2 Key B** pinout, which is commonly used for WAN (LTE/5G) or storage expansion.
```markdown
Pin Configuration (Simplified):
- Pins 1-11: Power and Ground (GND/3.3V)
- Pins 12-19: USB 2.0 / PCIe Lane signals (depending on specific model variant)
- Pins 20-75: Interface control signals and reserved pins
```
---
### Key Applications
* **Industrial IoT:** Adding removable logging storage to fanless PC units.
* **Embedded Systems:** Providing a bootable OS drive via an SD card where SSDs are not cost-effective.
* **Data Recovery:** Testing SD cards through a high-speed motherboard interface.
- ⤷
What is the maximum SD card capacity supported by the M2REB-SD3-R2?
- ⤷ Does this module require specific drivers for Windows or Linux?
- ⤷ Can this adapter be used in an M.2 Key M (NVMe) slot?