LOR34T-R150-K
AI

Based on the technical nomenclature, the **LOR34T-R150-K** typically refers to a high-precision, low-resistance **Current Sense Resistor** (Shunt Resistor). These components are vital for power management systems to monitor current flow by measuring the voltage drop across the resistor.
---
### 1. Part Number Breakdown (Estimated)
While specific manufacturer prefixes can vary, the nomenclature generally breaks down as follows:
| Segment | Meaning | Description |
| :--- | :--- | :--- |
| **LOR** | Series Type | Low Ohmic Resistor / Metal Plate Shunt. |
| **34T** | Case Size | Often corresponds to a specific physical footprint (e.g., 2512 or 4-terminal kelvin). |
| **R150** | Resistance Value | **150 mΩ (0.150 Ohms)**. The 'R' acts as a decimal point. |
| **K** | Tolerance | **±10%** (though some series use K for ±1%). |
---
### 2. Technical Specifications
These parts are engineered for high stability and low thermal noise.
* **Technology:** Metal plate or metal alloy construction. This allows for high current handling without the risk of burning out like standard thick-film resistors.
* **Inductance:** Low self-inductance, making it suitable for high-frequency switching power supplies.
* **TCR (Temperature Coefficient of Resistance):** Usually very low (e.g., ±50ppm/°C to ±100ppm/°C) to ensure accuracy across a wide temperature range.
* **Power Rating:** Depending on the package size, these typically range from **1W to 3W**.
---
### 3. Application Use Cases
The LOR34T-R150-K is used in circuits where current needs to be converted into a measurable voltage signal.
1. **Battery Management Systems (BMS):** Monitoring charge and discharge cycles in Li-ion packs.
2. **DC-DC Converters:** Providing feedback for over-current protection (OCP).
3. **Motor Control:** Sensing phase current to manage torque and speed.
4. **Power Inverters:** Used in solar or automotive electronics to track power throughput.
---
### 4. Implementation Diagram (Conceptual)
```c
// Current Measurement Logic (Ohm's Law: V = I * R)
// If R = 150mOhm (0.150 Ohms)
// If measured Voltage (V_drop) = 150mV
// Then Current (I) = 1 Ampere
```
---
- ⤷
What is the exact physical package size for the 34T series?
- ⤷ Does this resistor support 4-terminal Kelvin sensing for higher accuracy?
- ⤷ What is the maximum wattage rating for the R150-K variant?