công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

  • LCM-H12864GSF-R-Y

  • AI
    ## Technical Overview: LCM-H12864GSF-R-Y The **LCM-H12864GSF-R-Y** is a Graphic Liquid Crystal Display (GLCD) module, commonly used in industrial equipment, medical devices, and embedded systems. It is characterized by its 128x64 pixel resolution and yellow-green backlight. ### 1. Key Technical Specifications | Feature | Specification | | :--- | :--- | | **Resolution** | 128 x 64 Pixels | | **Display Mode** | STN (Super-Twisted Nematic) | | **Backlight Type** | LED (Yellow-Green) | | **Polarizer Mode** | Transflective / Positive | | **Controller/Driver** | Usually NT7107/NT7108 (or equivalent like KS0108) | | **Operating Voltage** | 5V (Typical) | | **Interface** | 8-bit Parallel | --- ### 2. Electronic Component Breakdown The module consists of several critical electronic sub-systems: #### A. The Display Controller (IC) The most common controller for this model is the **KS0108** or **NT7108**. This IC handles the communication between your microcontroller (MCU) and the pixel matrix. * **Segment Drivers:** Drive the vertical columns. * **Common Drivers:** Drive the horizontal rows. #### B. Internal Voltage Generator To create the contrast required for the liquid crystals, the module often requires a negative voltage (VEE). * **Vout / Vee:** Most modules generate approximately -5V to -10V internally or require an external negative supply to adjust the contrast via a potentiometer. #### C. Backlight Circuitry The yellow-green backlight is powered by an LED array. * **Anode (A) / Cathode (K):** Usually pins 19 and 20. * **Current Limiting:** A resistor is often required to prevent burning out the LEDs if the supply voltage exceeds 4.2V - 5V. --- ### 3. Pinout Configuration (Standard 20-Pin) | Pin No. | Symbol | Description | | :--- | :--- | :--- | | 1 | VSS | Ground (0V) | | 2 | VDD | Power Supply (+5V) | | 3 | VO | Contrast Adjustment | | 4 | D/I (RS) | Data / Instruction Select | | 5 | R/W | Read / Write Select | | 6 | E | Enable Signal | | 7-14 | DB0-DB7 | 8-bit Data Bus | | 15 | CS1 | Chip Select 1 (Left half of screen) | | 16 | CS2 | Chip Select 2 (Right half of screen) | | 17 | RST | Reset Signal | | 18 | VEE | Negative Voltage Output (for contrast) | | 19 | LEDA | Backlight Anode (+) | | 20 | LEDK | Backlight Cathode (-) | --- ### 4. Implementation Example (C/C++ Pseudocode) To initialize the display in an embedded environment: ```cpp // Basic command sequence for initialization void GLCD_Init() { LCD_WriteCommand(LCD_ON); // Turn display on LCD_WriteCommand(SET_ADDRESS); // Set X/Y address to 0 LCD_WriteCommand(START_LINE); // Set display start line to 0 LCD_Clear(); // Clear the GDRAM } ``` ---
    ✨ Follow-up Questions
    • ⤷ What is the maximum current draw for the LED backlight?
    • ⤷ How do I wire a potentiometer for contrast adjustment on this specific model?
    • ⤷ Is this display compatible with 3.3V logic levels without a level shifter?