KWMS2-2E-R/Q
AI

The **KWMS2-2E-R/Q** is a high-performance, ultra-compact motion sensor module based on **Microwave (Doppler) technology**. It is widely used in smart lighting, security systems, and IoT devices due to its high sensitivity and resistance to environmental interference (like wind or temperature changes).
---
### 1. Key Technical Specifications
Below are the electronic characteristics typically associated with the KWMS2 series (R/Q variants):
| Parameter | Specification | Note |
| :--- | :--- | :--- |
| **Operating Voltage** | 3.3V - 5V DC | Stable regulated power is recommended |
| **Output Type** | High/Low Level (TTL) | High when motion is detected |
| **Frequency** | ~5.8 GHz | C-band microwave frequency |
| **Power Consumption** | < 10mA | Low power profile for energy efficiency |
| **Sensing Distance** | 2m - 12m | Often adjustable via onboard resistor |
| **Delay Time** | 2s - 30s | Configurable duration of the "High" signal |
---
### 2. Electronic Component Breakdown
The module consists of several critical stages that process the microwave signal:
#### A. Microwave Transceiver
This is the heart of the module (usually a planar antenna integrated on the PCB). It emits a high-frequency electromagnetic wave. When this wave hits a moving object, it reflects back with a frequency shift (the **Doppler Effect**).
#### B. Signal Amplification & Filtering
The reflected signal is extremely weak. The module utilizes **Operational Amplifiers (Op-Amps)** to:
* Filter out low-frequency noise (like power line hum).
* Amplify the Doppler shift signal to a level that can be processed.
#### C. Comparator / Processing IC
The "R/Q" variants often feature a specific control IC that compares the amplified signal against a reference threshold. If the signal exceeds the threshold, the IC triggers the output pin.
#### D. Photosensitive Interface (LDR)
Many "Q" versions include a pin for a **Light Dependent Resistor (LDR)**. This allows the electronic circuit to be "inhibited" during daylight hours, ensuring the sensor only triggers at night to save energy.
---
### 3. Pin Configuration
The module generally follows a standard 3-pin or 5-pin layout:
1. **VCC**: Power Supply (+).
2. **GND**: Ground (-).
3. **OUT**: Output signal (Digital 3.3V high).
4. **CDS (Optional)**: Connection for an external light sensor.
5. **ADJ (Optional)**: Connection for a potentiometer to adjust range/time.
---
### 4. Comparison: Microwave vs. PIR
| Feature | KWMS2 (Microwave) | Traditional PIR |
| :--- | :--- | :--- |
| **Detection Method** | Active (Microwave reflection) | Passive (Heat/Infrared) |
| **Penetration** | Can sense through glass/thin walls | Blocked by glass/plastic |
| **Temp. Sensitivity** | Not affected by ambient heat | Accuracy drops in hot weather |
---
- ⤷
What is the difference between the 'R' and 'Q' suffixes in this part number?
- ⤷ How can I adjust the sensing distance of the KWMS2-2E-R/Q?
- ⤷ Can this sensor be used behind a plastic enclosure?