HTS-1B-R/Q
AI

The **HTS-1B-R/Q** typically refers to a high-precision, industrial-grade **Current Transducer** or **Hall Effect Sensor**. These components are designed to measure electrical current (AC, DC, or pulsed) without physical contact with the conductor, providing galvanic isolation.
---
## 1. Technical Specifications
The following table outlines the typical electrical characteristics of the HTS series sensors:
| Parameter | Typical Value / Range |
| :--- | :--- |
| **Primary Current ($I_{pn}$)** | 100A - 500A (Model dependent) |
| **Supply Voltage ($V_c$)** | ±15V DC (Dual Supply) |
| **Output Type** | Instantaneous Analog (Current or Voltage) |
| **Accuracy** | ±0.5% to ±1% |
| **Linearity** | < 0.1% |
| **Response Time** | < 1 µs |
| **Frequency Range** | DC to 50 kHz |
---
## 2. Key Electronic Components & Technology
The "R/Q" suffix usually denotes specific variations in the output resistance or mounting configuration.
### A. Closed-Loop Hall Effect Technology
The device operates on the **Closed-Loop (compensated)** principle.
1. **Hall Element:** A thin semiconductor detects the magnetic field generated by the primary current.
2. **Compensation Coil:** An internal secondary winding creates an opposing magnetic field to "cancel out" the primary field.
3. **Zero Flux:** The sensor maintains a "zero magnetic flux" state, which ensures high linearity and low temperature drift.
### B. Galvanic Isolation
Because there is no direct electrical connection between the high-power primary circuit and the low-power sensing circuit, the HTS-1B protects sensitive microcontrollers and control systems from surges.
---
## 3. Pinout & Integration
Most HTS series sensors utilize a standard 3 or 4-pin interface:
| Pin Number | Label | Description |
| :--- | :--- | :--- |
| 1 | **+Vc** | Positive Supply (+15V) |
| 2 | **-Vc** | Negative Supply (-15V) |
| 3 | **M / Out** | Measurement Output (Current signal) |
| 4 | **GND** | Ground / Common |
### Application Circuit Example
To read the signal with an Arduino or PLC, a burden resistor ($R_m$) is required to convert the output current into a measurable voltage:
```cpp
// Basic logic for reading a Current Transducer output
int sensorPin = A0;
float sensitivity = 0.1; // Example: Volts per Amp
float offset = 2.5; // Center voltage for AC
void loop() {
int rawValue = analogRead(sensorPin);
float voltage = (rawValue / 1024.0) * 5.0;
float current = (voltage - offset) / sensitivity;
// Further processing...
}
```
---
## 4. Common Applications
* **Variable Speed Drives (VSD):** Monitoring motor current for precise speed control.
* **Uninterruptible Power Supplies (UPS):** Managing battery charging and load distribution.
* **Welding Machines:** Ensuring stable current output during high-power operations.
* **Solar Inverters:** Converting DC current from panels to AC for the grid.
- ⤷
What is the difference between Open-Loop and Closed-Loop Hall Effect sensors?
- ⤷ How do I calculate the burden resistor value for the HTS-1B-R?
- ⤷ Can this sensor be used for both AC and DC current measurements simultaneously?