công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

  • FRTS-A4-R/Q

  • AI
    The **FRTS-A4-R/Q** is a specific variant of the **Linear Potentiometer** (Contact Displacement Sensor) manufactured by **Keyence**. This series is widely used in industrial automation for high-precision distance and thickness measurements. Below is a breakdown of the electronic specifications and functional components of this device. --- ## 1. Key Technical Specifications The electronics of the FRTS-A4-R/Q are designed for low-noise signal transmission and high-speed feedback. | Parameter | Specification | | :--- | :--- | | **Measurement Range** | 4 mm | | **Output Type** | Analog (Typically 4-20 mA or 0-5V depending on amplifier) | | **Linearity** | ±0.1% of F.S. | | **Resolution** | 0.5 μm | | **Response Frequency** | 10 Hz | | **Connection Type** | M12 Connector (Q-model) or Lead wire (R-model) | --- ## 2. Electronic Parts & Internal Components ### A. Potentiometric Sensing Element At its core, the FRTS uses a **Conductive Plastic Track**. * **The Element:** A high-precision resistive track. * **The Wiper:** A multi-finger metal brush attached to the moving shaft. * **Operation:** As the probe moves, the wiper changes its position on the track, altering the electrical resistance and creating a voltage divider. ### B. Signal Conditioning Circuitry Inside the sensor head or the dedicated amplifier: * **A/D Converter:** Converts the analog voltage from the resistive element into a digital signal (in newer digital units). * **Filtering:** Low-pass filters are used to eliminate mechanical vibration noise from the electrical signal. * **Linearization Circuit:** Compensates for any non-linearity in the resistive track to ensure the output is perfectly proportional to displacement. ### C. Connectors and Cables * **FRTS-A4-Q (Quick-disconnect):** Features an **M12 4-pin electronic connector**. This allows for easy replacement without re-wiring. * **FRTS-A4-R (Robot Cable):** Uses a high-flexibility cable designed for moving parts (robotic arms). The electronics are shielded to prevent Electromagnetic Interference (EMI). --- ## 3. Wiring Diagram Principles To integrate these parts into a PLC or Controller, the typical pinout logic is as follows: ```plaintext Pin 1: Brown (+) Power Supply (typically 12-24V DC) Pin 2: White (Output) Analog Signal Pin 3: Blue (-) Common/Ground Pin 4: Black (Control/Shield) Ground reference ``` --- ## 4. Operational Requirements To protect the internal electronic parts, the following precautions must be taken: 1. **Overvoltage Protection:** Use a regulated DC power supply to avoid blowing the internal resistive bridge. 2. **Impedance Matching:** The input impedance of the receiving device (PLC) should be high to avoid "loading" the sensor, which causes measurement errors. 3. **EMI Shielding:** Since it is an analog device, keep the signal cable away from high-voltage motor cables to prevent "ghost" readings.
    ✨ Follow-up Questions
    • ⤷ What is the difference between the R and Q suffixes in terms of durability?
    • ⤷ How do I calibrate the analog output for this sensor in a PLC?
    • ⤷ Can this sensor be used with a Keyence DL series communication unit?