PIC18F242 datasheet(132/332 Pages) MICROCHIP

132 / 332 page

PIC18FXX2

DS39564C-page 130

15.3.5

MASTER MODE

The master can initiate the data transfer at any time

because it controls the SCK. The master determines

when the slave (Processor 2, Figure 15-2) is to

broadcast data by the software protocol.

In Master mode, the data is transmitted/received as

soon as the SSPBUF register is written to. If the SPI is

only going to receive, the SDO output could be dis-

abled (programmed as an input). The SSPSR register

will continue to shift in the signal present on the SDI pin

at the programmed clock rate. As each byte is

received, it will be loaded into the SSPBUF register as

if a normal received byte (interrupts and status bits

appropriately set). This could be useful in receiver

applications as a “Line Activity Monitor” mode.

The clock polarity is selected by appropriately program-

ming the CKP bit (SSPCON1<4>). This then, would

give waveforms for SPI communication as shown in

Figure 15-3, Figure 15-5, and Figure 15-6, where the

MSB is transmitted first. In Master mode, the SPI clock

rate (bit rate) is user programmable to be one of the

following:

•FOSC/4 (or TCY)

•FOSC/16 (or 4 • TCY)

•FOSC/64 (or 16 • TCY)

• Timer2 output/2

This allows a maximum data rate (at 40 MHz) of

10.00 Mbps.

Figure 15-3 shows the waveforms for Master mode.

When the CKE bit is set, the SDO data is valid before

there is a clock edge on SCK. The change of the input

sample is shown based on the state of the SMP bit. The

time when the SSPBUF is loaded with the received

data is shown.

FIGURE 15-3:

SPI MODE WAVEFORM (MASTER MODE)

SCK

(CKP = 0

SCK

(CKP = 1

SCK

(CKP = 0

SCK

(CKP = 1

4 Clock

Modes

Input

Sample

Input

Sample

SDI

bit7

bit0

SDO

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

bit7

bit0

SDI

SSPIF

(SMP = 1)

(SMP = 0)

(SMP = 1)

CKE = 1)

CKE = 0)

CKE = 1)

CKE = 0)

(SMP = 0)

Write to

SSPBUF

SSPSR to

SSPBUF

SDO

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

(CKE = 0)

(CKE = 1)

Next Q4 cycle

after Q2

↓

PIC18F242 bảng dữ liệu(PDF) 132 Page - Microchip Technology

PIC18F242 bảng dữ liệu(HTML) 132 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL