DSPIC30F2010 datasheet(158/236 Pages) MICROCHIP

158 / 236 page

dsPIC30F6010A/6015

DS70150C-page 156

Concurrently, the POR time-out (TPOR) and the PWRT

time-out (TPWRT) will be applied before the internal

Reset is released. If TPWRT = 0 and a crystal oscillator

is being used, then a nominal delay of TFSCM = 100

μs

applied.

The

total

delay

this

case

(TPOR +TFSCM).

The BOR Status bit (RCON<1>) will be set to indicate

that a BOR has occurred. The BOR circuit, if enabled,

will continue to operate while in Sleep or Idle modes

and will reset the device should VDD fall below the BOR

threshold voltage.

FIGURE 21-6:

EXTERNAL POWER-ON

RESET CIRCUIT (FOR

SLOW VDD POWER-UP)

Note:

Dedicated supervisory devices, such as

the MCP1XX and MCP8XX, may also be

used as an external Power-on Reset

circuit.

Note 1: External Power-on Reset circuit is

required only if the VDD power-up slope

is too slow. The diode D helps discharge

the capacitor quickly when VDD powers

down.

2: R should be suitably chosen so as to

make sure that the voltage drop across

R does not violate the device’s electrical

specification.

3: R1 should be suitably chosen so as to

limit any current flowing into MCLR from

external capacitor C, in the event of

MCLR/VPP pin breakdown due to Elec-

trostatic Discharge (ESD) or Electrical

Overstress (EOS).

VDD

dsPIC30F

MCLR

DSPIC30F2010 bảng dữ liệu(PDF) 158 Page - Microchip Technology

DSPIC30F2010 bảng dữ liệu(HTML) 158 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL