INTEDG datasheet(235/478 Pages) MICROCHIP

235 / 478 page

 2010-2012 Microchip Technology Inc.

DS41414D-page 235

PIC16(L)F1946/47

23.4.6

PWM STEERING MODE

In Single Output mode, PWM steering allows any of the

PWM pins to be the modulated signal. Additionally, the

same PWM signal can be simultaneously available on

multiple pins.

Once

the

Single

Output

mode

selected

(CCPxM<3:2> = 11 and PxM<1:0> = 00 of the

CCPxCON register), the user firmware can bring out

the same PWM signal to one, two, three or four output

pins by setting the appropriate STRx<D:A> bits of the

PSTRxCON register, as shown in Table 23-9.

While the PWM Steering mode is active, CCPxM<1:0>

bits of the CCPxCON register select the PWM output

polarity for the Px<D:A> pins.

The PWM auto-shutdown operation also applies to

PWM Steering mode as described in Section 23.4.3

“Enhanced PWM Auto-shutdown mode”. An

auto-shutdown event will only affect pins that have

PWM outputs enabled.

FIGURE 23-18:

SIMPLIFIED STEERING

BLOCK DIAGRAM

Note:

The associated TRIS bits must be set to

output (‘0’) to enable the pin output driver

in order to see the PWM signal on the pin.

TRIS

PxA pin

PORT Data

PxA Signal

STRxA

TRIS

PxB pin

PORT Data

STRxB

TRIS

PxC pin

PORT Data

STRxC

TRIS

PxD pin

PORT Data

STRxD

Note 1: Port outputs are configured as shown when

the CCPxCON register bits PxM<1:0> = 00

and CCPxM<3:2> = 11.

2: Single PWM output requires setting at least

one of the STRx bits.

CCPxM1

CCPxM0

CCPxM1

CCPxM0

INTEDG bảng dữ liệu(PDF) 235 Page - Microchip Technology

INTEDG bảng dữ liệu(HTML) 235 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL