SPEC No.

LC9

LC9

LC9

LC98109A

8109A

8109A

8109A

MODEL No.

LM

LM

LM

LM8M64

8M64

8M64

8M64

PAGE

3333

13) Procedure insert mating connector

When the mating connector is inserted, it should be parallel to the used connector of LCD module and it

should be inserted horizontally.

When the mating connector is attempted to be fixed to LCD connector, it should be inserted properly in order

not to create a gap as shown “A”.

Please insert the connector as both edge is placed to the connect position of LCD connector.

LCD Connector

Parallel

LCD Connector

Ａ

LCD Connector

14) This specification describes display quality in case of no gray scale. Since display quality can be affected by

gray scale methods, display quality shall be carefully evaluated for the usability of LCD module in case gray

scale is displayed on the LCD module.

15) The module should be driven according to the specified ratings to avoid permanent damage.

DC voltage drive leads to rapid deterioration of LC, so ensure that the drive is alternating waveform by

continuous application of the signal M. Especially the power ON/OFF sequence shown on Page 24 should be

kept to avoid latch-up of drive LSIs and application of DC voltage to LCD panel.